EXPERIMENT GUIDES
Pick one. Book a bench. Run it.
Full protocols with apparatus lists, step-by-step technique, safety notes, and the results you should expect — so you know when you've nailed it.
10 of 19 experiments
Titration: ethanoic acid vs sodium hydroxide
The classic weak acid–strong base titration. Standardise 0.1 M ethanoic acid against 0.1 M NaOH using phenolphthalein, and see why the endpoint lands above pH 7.
Flame tests: identifying metal ions
Dip, flame, identify. Use the colours metal ions give a Bunsen flame to identify unknown salts — the same physics that puts colour in fireworks.
Food tests: starch, sugars, protein and fat
Four classic bench tests — iodine, Benedict's, biuret and the emulsion test — run on real food samples to detect the major nutrients.
Microscopy: onion epidermal cells
Prepare a wet mount of onion epidermis, stain it with iodine, and draw what you actually see at ×40 and ×400 — cell walls, nuclei and all.
Ohm's law: V–I characteristics of a resistor
Build the classic ammeter-voltmeter circuit, vary the current with a rheostat, and show that V/I is constant for a fixed resistor at constant temperature.
Simple pendulum: measuring g
Time a swinging pendulum at five lengths, plot T² against L, and extract the acceleration due to gravity from the gradient. Expect within 2% of 9.81 m/s².
Qualitative analysis: identifying the ions in two unknown solids
Two labelled solids, a rack of reagents and no answers. Work through the standard test series, record what you actually see, and name the ions from the evidence.
Moments: finding the weight of an unknown mass
Balance a metre ruler pivoted at its centre against an unmarked mass Q, using a 2.0 N load and then a 3.0 N load, and use the principle of moments to find Q's weight two independent ways.
Resistance of a wire: R depends on length (slide-wire method)
Tape ~105 cm of bare constantan wire to a metre rule, slide a contact along it to vary the length between a fixed terminal and the contact, and show that resistance is directly proportional to length.
Refraction through a rectangular glass block
Trace a ray of light into a rectangular glass block with optics pins, sight through the far side to find where it emerges, and show the emergent ray is parallel to the incident ray — displaced sideways, but travelling in the same direction. Measure the angle to confirm it equals the original angle of incidence.